EDC For CCW: Benchmade 484

Image courtesy Benchmade Knives

I’ve gotten so used to Benchmade flippers that I’m surprised when I see the trademark butterfly on a knife that doesn’t have one. Such is the Benchmade 484, a new thumbstud-opener designed by Seiichi Nakamura.

Image courtesy Benchmade Knives

Namakura has designed lovely collaborations for Benchmade before, including this winewood-handled Model 480 Shoki. The Shoki was the IWA international knife of the year in 2008, and its S30V blade steel was pretty durn’ fancy at the time. Benchmade now describes this discontinued model as an ‘ultimate pocket accessory.’

The 484 doesn’t quite have the black-tie elegance of the 480, but it does have an AXIS lock and the latest in superdupersteel blades. The 3.08″modified drop point is made of top-shelf M390 with a hardness of 60-62 HRC. It’s also got sculpted G10 scales, stainless steel liners, and a reversible tip-up pocket clip.

The 484 is so new it’s not available yet, but can be preordered from Benchmade for (only?) $225.


  1. G says:

    Very handsome blade…

  2. SigGuy says:

    Oooh M390…

  3. MD says:

    Looks pretty. And kinda heavy with those stainless liners. For me, its hard to beat the 940: Light, decent blade length, Axis lock and cool aesthetics.

    P.S. – Chris, I’m surprised you’re so used to Benchmade flippers. As far as I know, they only make a few models with flippers (Axis 300 and …..?). And the flipper is a relatively recent addition for Benchmade.

  4. mrpiggy fingers says:

    I like it…out of my 100 or so knives my favorite edc is my Benchmade 710 axis in D2 steel.The 710 is 4 inch rather than 3 but otherwise quite similar.

Write a Comment

Your email address will not be published. Required fields are marked *

EDC For CCW: Benchmade 484

button to share on facebook
button to tweet
button to share via email